LG LWD3063BD Owners Manual - Installation Guide - Page 11
Install The Oven - wall oven
View all LG LWD3063BD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Part 4 INSTALL THE OVEN ENGLISH 1 CABINET INSTALLATION The fifth step of the installation is to install the oven into the cabinet as follows: 1. Sliding the oven into the opening. a. Loop (do not tie) a 36" (91 cm) string around the conduit before the oven is slid into place.This will keep the conduit from falling behind the oven. b. Lift oven into cabinet cutout using the oven opening as a grip. Carefully push against the oven front frame. Do not push against outside edges. c. While sliding the oven back, pull the string so that the conduit lies on the top of the oven in a natural loop. d. When you are sure the conduit is out of the way, slide the oven 3/4 way back into the opening. Remove the string by pulling on one end of the loop. CAUTION • D O NOT block the oven air exhaust located at the bottom of the oven. - Blocking the exhaust may cause cabinet damage and product malfunction. WARNING • Mounting screws must be used. - Failure to do so can result in the oven falling out of the cabinet causing serious injury. 2. Securing the oven. a. Using the mounting holes on the oven side trim as a guide, drill pilot holes for screws provided (For securing the double wall oven, use a minimum of 4 screws, one on each side in both the upper and lower ovens. For securing the single wall oven, use a minimum of 2 screws, one on each side.) b. Secure the oven to the cabinet with screws provided. If the cabinet is particle board, you must use 3/4" particle board screws. These may be purchased at any hardware store. 3. Installing the metal bottom trim. (For model : LWS3081ST, LWD3081ST, LWS3010ST, LWD3010ST) a. Place the metal bottom trim centered over the predrilled mounting holes on the lower base. b. Using 3 screws provided, secure the bottom trim to the bottom edge of the cabinet. 4. Reinstalling the oven door. (For model :LWS3081ST, LWD3081ST, LWS3010ST, LWD3010ST) Mounting Hole Locations Mounting Hole Locations Trim Screws Side Trim Side Trim Metal bottom trim Lower base Metal Trim: Correct position Metal Trim: Wrong position Step. 1 Firmly grasp both sides of the door at the top. Step. 3 Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot. Step. 2 Hinge arm With the door at the same angle as the removal position, seat the indentation of the hinge arm into the bottom edge of the hinge slot. The notch in the hinge arm must be fully seated into the bottom of the slot. Bottom edge of slot Indentation Step. 4 Push the hinge locks up against the front frame of the oven cavity to the locked position. Step. 5 Close the oven door. - 11 - Hinge arm Hinge lock