LG LWD3063BD Owners Manual - Installation Guide - Page 5
Part 2 - installation
View all LG LWD3063BD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ENGLISH Part 2 INSTALLATION REQUIREMENTS 2 INSTALLATION DRAWINGS (FOR 30" DOUBLE BUILT- IN OVEN) The first step of the installation is measure the current cutout dimensions and compare them to the cutout dimensions shown below. Little or no cabinet work may be necessary. IMPORTANT NOTE • T he cabinet base platform must be able to support 325lbs (147kg). If the cabinet does not have a solid bottom, two braces or runners must be installed level with the bottom of the cutout to support the weight of the oven. Make sure the base is level and the front of the cabinet is square. If the cabinet base is not level, the oven glides will tend to slide out when opening the door. • If marks, blemishes or the cutout opening are visible above the installed oven, it may be necessary to add wood shims under the runners and front trim until the marks or opening are covered. • If the cabinet does not have a front frame and the sides are less than 3/4" (1.9 cm) thick, shim both sides equally to establish the cutout width. • The junction box must be flush with the rear wall of the cabinet as shown below. • Allow at least a 23" clearance for the door depth when it is open. • Kitchen cabinets in contact with the oven must be heat resistant up to 194°F (90°C), and fronts of nearby units up to at least 158°F (70°C). Product dimensions 27 3/8" (69.5 cm) 52 1/16" (132.2 cm) 51 5/8" (131.0 cm) 29 3/4" (75.5 cm) Cutout dimensions Cabinet Width Recommended Minimum Cutout Location from Floor 30" (762 mm) 12" (304.8 mm) Allow 1" minimum for overlap of oven Cutout Depth 23 1/2" Min. (596.9 mm) Cutout Width 28 1/2" Min. (723.9 mm) 28 5/8" Max. (727 mm) Cutout Height 51 13/16" Min. (1316 mm) 23" 51 15/16" Max. (1319.2 mm) - 5 - 23 3/8" (59.3 cm) 30" 28 1/2" Min. 28 5/8" Max. 5" Junction Box Location Allow 1" 47" minimum for 51 13/16" Min. overlap of oven 51 15/16" Max. 23 1/2" Minimum cutout location from floor 12"