LG U9CV1C Owners Manual - Page 17
Warning, Caution
View all LG U9CV1C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
EN WARNING •• The remote controller uses button/coin type batteries (CR2025). •• Swallowing batteries may cause serious injury or death. Go to hospital emergency room immediately to seek medical attention. •• Keep the battery out of reach of children. •• If the battery tray is not secured firmly, stop using the appliance immediately and keep it away from children. •• The remote controller signal reception may be interrupted when strong lights such as fluorescent lamps or neon signs are present. In this case, use the remote controller in front of the remote signal receiver of the indoor unit. Getting Started Press the Standby On/Off button to start operation. CAUTION •• Do not arbitrarily modify the battery. •• Do not recharge or disassemble the battery. •• Do not throw the battery into a fire for disposal or leave it near heat. •• Do not press multiple buttons at the same time. •• Do not use it in a place with a lot of water or moisture. •• Do not use it in a place with flames or heat. •• Remove and store the battery in a safe location if you do not intend to use the remote controller for a long time. Note •• If the remote controller is not operating properly, check the polarity (+, -) of the battery or replace the battery before contacting the service center. •• When using the remote controller, point the remote controller transmitter toward the receiver on the product. •• The remote controller is not received properly at a distance of more than 7 m from the product. Note •• When starting operation for the first time after installing the product, it will operate in Wide mode and with step 5 of fan speed. •• If you stop operation and resume it, it will start cleaning with the mode you last selected. •• Even if power is lost due to a blackout, the product will remember the mode(Fan speed, Mode, Display brightness) you used last. •• When you start driving, the dust concentration is displayed after sensor stabilization (about 15 seconds). While sensor stabilization is in progress, the clean stabilization screen ( ) appears on the status display. 17