LG WM2140CW Owner's Manual - Page 25

ENGLISH CARE AND CLEANING REGULAR CLEANING wWARNING: • Unplug the washer before cleaning to avoid the risk of electric shock. Failure to follow this warning can cause serious injury, fire, electrical shock, or death. • Never use harsh chemicals, abrasive cleaners, or solvents to clean the washer. They will damage the finish. Cleaning the Exterior Proper care of your washer can extend its life. The outside of the machine can be cleaned with warm water and a mild, nonabrasive household detergent. Read these instructions carefully before beginning the TUB CLEAN cycle. 1 Open the door and remove any clothing in the wash drum. Immediately wipe off any spills with a soft, damp cloth. 2 Open the dispenser drawer. IMPORTANT: Do not use methylated spirits, solvents, or similar products. Never use steel wool or abrasive cleansers; they can damage the surface. Care and Cleaning of the Interior 3 Add liquid chlorine bleach or tub cleaner. Some powder or tablet tub cleaners which are manufactured for this purpose can be used. Use a towel or soft cloth to wipe around the washer door opening, door seal, and door glass. These areas should be kept clean to ensure a watertight seal. Be sure to wipe under the inside rubber seal to remove any moisture or soil. Always remove items from the washer as soon as the cycle is completed. Leaving damp items in the washer can cause wrinkling, color transfer, and odor. Run the TUB CLEAN cycle regularly to remove detergent buildup and other residue. NOTE: If you use the TUB CLEAN cycle on a monthly basis, the wash drum will be kept clean. Removing stains on the Door Seal NOTE: Wear rubber gloves and eye protection while performing the following procedure: 1 Dilute ¾ cup (177 ml) liquid chlorine bleach with 1 gallon (3.8 L) of warm/hot water. 2 Use this solution to wipe down all surfaces of the gasket to remove the deposits that are causing any odor. (Be sure to fold back the lip of the gasket to get under the edge where residue can build up.) 3 Wipe the gasket with a dry cloth. 4 Leave the door open to allow the gasket to dry completely. Do not use undiluted bleach as this will damage the gasket. Follow the manufacturer's instructions for proper use of bleach. If the gasket cannot be cleaned properly, it should be replaced. (NOTE : Do not add any laundry detergent or fabric softener to the drawer when using TUB CLEAN.) - If using liquid chlorine bleach Add liquid chlorine bleach to the bleach compartment of the drawer. (NOTE : Do not exceed the maximum fill line and do not pour undiluted liquid bleach directly into the wash drum.) - If using powder cleaner Remove the liquid detergent cup and add powder cleaner to the main wash compartment of the drawer. - If using tablet cleaner Add tablet cleaner to the wash drum directly. (NOTE : Do not add tablet cleaner to the drawer.) 4 Close the drawer and washer door. 5 Select TUB CLEAN and press START/PAUSE. NOTE : It is recommended that TUB CLEAN should be repeated monthly. If mildew or musty smell already exists, run TUB CLEAN for 3 consecutive weeks. After TUB CLEAN is complete or when the washer is not used, leave the washer door open for better ventilation and drying inside of the washer. MFL62526858_en_100728.indd 25 25 7/28/10 4:20:44 PM