LG WM2233HW Owner's Manual - Page 23

TROUBLESHOOTING GUIDE Problem Possible Cause Solution • Water supply is not adequate in area. • Water supply taps are not completely open. • Water inlet hose is bent. • The filter of the inlet hose clogged. Check another tap in the house. Fully open tap. Straighten hose. Check the filter of the inlet hose. • Drain hose is bent or clogged. • The drain filter is clogged. Clean and straighten the drain hose. Clean the drain filter. • Load is too small. • Load is out of balance. • The appliance has an imbalance detection and correction system. If individual heavy articles are loaded (bath mat, bath robe, etc.) and the imbalance is too great, after several attempts to restart the spin cycle the machine will stop and the error code will be displayed. Add 1 or 2 similar items to help balance the load. Rearrange load to allow proper spinning. • Is the door opened or not completely closed? Close the door completely. If it is not released, call for service. • The water overfills due to the faulty water valve. • The water level sensor malfunction. • Overload in motor. • The washer experienced a power failure. Unplug the power plug and call for service. Close the water tap. Unplug the power plug. Call for service. Restart the cycle after 30 minutes. If LE is not released, call for service. Restart the cycle. 22