LG WT5070CV Owners Manual - English Spanish - Page 16
Leveling, Washing, machine
View all LG WT5070CV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
16 INSTALLATION INSTRUCTIONS Leveling the Washing machine The washer spins at very high speeds, up to 1,100 RPM. -0 NOTE • Adjust the leveling feet only as far as necessary to level the washer. Extending the leveling feet more than necessary can cause the washer to vibrate. • All four leveling feet must rest solidly on the floor. Rock the washer gently from corner to corner to make sure that the washer does not rock. • Before installing the washer, make sure the floor is clean, dry and free of dust, dirt, water and oils so the washer feet cannot slide easily. Leveling feet that can move or side on the floor can contribute to excess vibration and noise due to poor contact with the floor. J 1 Position the washer in the final location, taking special care to not pinch, strain, or crush the water and drain lines. Place a level across the top of the washer. 2 Adjust the leveling feet. Turn clockwise to raise the washer or counterclockwise to lower it. J Raise And Lower 3 To make sure that the washer is properly level, open the lid and look from above to see if it is same as shown below. If you have a level, check your washer with the level. side to side front to back Lower Raise 1Z If the washer is not level, adjust the leveling feet. Turn clockwise to raise, counterclockwise to lower. 4 Check the washing machine's level again. - Push or rock the top edges of the washing machine gently to make sure that the washing machine does not rock. - If the washing machine rocks, repeat steps 1 to 3. - A WARNING • Using the washing machine without leveling, it may result in malfunction caused by the production of excess vibration and noise. • Use the leveling feet only when you level the washing machine. If you raise the leveling feet unnecessarily, it may cause abnormal vibration of the washing machine. • To check if the washer is level side to side, close the lid and place a level at the back of the lid. • To check if the washer is level front to back, place a level at the side of the washer on the edge where the cabinet side meets the top cover.