LG WT5680HWA Owners Manual - Page 36
ERROR CODES continued - repair manual
View all LG WT5680HWA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
36 TROUBLESHOOTING ERROR CODES (continued) Problem Possible Cause Solutions The display shows: Foreign objects, such as coins, pins, clips, etc., caught between the wash plate and the inner basket. Turn off the washer and then press the Power button. Press the spin speed button without selecting a cycle to drain and spin the load. When the spin is complete, remove the clothes and then find and remove any objects caught in the wash plate. Always check pockets, etc., before washing to prevent error codes or damage to the washer or clothing. Water in the washer drains slowly Drain hose is kinked, pinched, or or not at all, or the display shows: clogged Make sure the drain hose is free of clogs, kinks, etc., and is not pinched behind or under the washer. Drain discharge is more than 96 Adjust or repair drain. Maximum drain height inches above bottom of washer. is 96 inches (8 ft.) The display shows: The washer has detected an out of If the washer detects a load that is too far balance load. out of balance to spin, it will display this code while it is attempting to rebalance the load. The washer will add water and try to redistribute the load automatically. This display is for your information only, and no action is required. The display shows: If the uE rebalance (see above) is not successful, this error will be displayed. The automatic attempt to rebalance the load was not successful. The cycle has been paused to allow the load to be manually adjusted. The load is too small. Small loads may need additional items to be added to allow the washer to balance the loads. Heavy articles are mixed with lighter items. The load may have heavy items loaded with lighter items. Always try to wash articles of somewhat similar weight to allow the washer to evenly distribute the weight of the load for spinning. The load is out of balance. Manually redistribute the load if articles have become tangled preventing the automatic distribution from working properly. The display shows: Control error. Unplug the washer and wait 60 seconds. Reconnect power and try again. If the error reappears, call for service. The display shows : Water level is too high due to a faulty water valve. Close the water faucets, unplug the washer, and call for service. The display shows: The water level sensor is not working correctly. Close the water faucets, unplug the washer, and call for service. The display shows: The display shows: A motor error has occurred. Clutch error. Allow the washer to stand for 30 minutes and then restart the cycle. If the LE error code persists, call for service. Mechanical failure. Unplug the washer and call for service.