Lacie Spare 12big Rack Network User Manual - Page 18
Enclosure Installation Pre, Requisites
View all Lacie Spare 12big Rack Network manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
LaCie 12big Rack Network User Manual Installation page 18 2.3. Enclosure Installation PreRequisites NOTE: LaCie 12big Rack Network enclosures are supplied and delivered fully populated with drive carrier modules preinstalled. CAUTION: The LaCie 12big Rack Network Enclosure with all its component parts installed is too heavy for a single person to easily install into a Rack cabinet. The following procedures describe the installation of the LaCie 12big Rack Network enclosure and highlights any critical pre-requisite requirements and good handling practices which we encourage you to follow so as to ensure that a successful installation is achieved in the easiest manner. CAUTION: Ensure that you have fitted and checked a suitable antistatic wrist or ankle strap and observe all conventional ESD precautions when handling LaCie 12big Rack Network modules and components. Avoid contact with Backplane, Motherboard and PCI card components and module connectors, etc. 2.3.1. Preparation of Site and Host Server Before you begin, make sure that the site where you intend to set up and use your LaCie 12big Rack Network storage system has the following: ✦✦ Standard AC power from an independent source or a rack Power Distribution Unit with a UPS (universal power supply). 2.3.2. Unpacking the Enclosure System The package contents and unpacking procedure are outlined in Fig. 12. 2.3.3. Planning and Configuring Your Installation Before you begin installation you should become familiar with the configuration requirements of your LaCie 12big Rack Network system. Please refer to 2.2. Planning Your Installation for information on your overall system configurations. When planning your system configuration, please remember that: ✦✦ All LaCie 12big Rack Network enclosure drive bays must be filled with a Drive Carrier module or a Dummy Drive Carrier module, no bays should be left completely empty. Fig. 12 - Unpacking the Enclosure System