Lantronix EO2Px Series User Guide Rev F PDF 2.50 MB - Page 4

Introduction Transition Networks' Ethernet Over 2-Wire Extenders with PoE+ (EO2P) are used in pairs, with a local device required at one end and a remote device required at the other end of a UTP cable, to support delivery of power and data over UTP cables. These flexible extenders have a 10/100/1000Base-T RJ-45 connector or 100/1000Base-X SFP combo port allowing connection to either copper or fiber Ethernet devices. The Local device provides a Gigabit 2-wire terminal block or RJ-45 connection to provide SELV (Safety Extra Low Voltage) power over twisted pair cable to the Remote device. The Remote device receives data and power via the 2-wire terminal block or RJ-45 connection and provides either a 100/1000Base-X SFP or 10/100/1000Base-T RJ-45 connector output with PoE+ power for IP cameras, WAPs , or other PoE powered end devices. Power for the Local device can be supplied via a +48VDC power source that meets IEEE 802.3 af/at isolation requirements of 1500VAC or 2200VDC or via the designated 90 Watt power adapter. The designated 90 Watt power adapter is optional at the Remote device for additional power or for providing redundant power. Transition Networks EO2P are a flexible and cost-effective way to extend Ethernet networks at near Gigabit speeds and provide full PoE+ power to security cameras, WAPs or other IP end devices beyond the typical 100m Ethernet cable limit. The EO2P leverage the existing 18-24 AWG UTP (CAT6/5, CAT3, or 2-wires of other 18-24 AWG TP or UTP cable) cable infrastructure to provide data and SELV power to IP/Ethernet devices in remote locations, saving time and money over installing new cable and electric power when upgrading or extending networks. Ordering Information # EO2PSE4052-111 (Local) EO2PD4052-111 (Remote) 25148 Power Adapter RMS19-SA4-02 WMBL WMBD WMBD-F WMBV Description One 10/100/1000Base-T RJ-45 or one 100/1000Base-X SFP Combo Port and one 10/100/1000Base RJ-45 or 2-Wire Terminal Block Combo Port; PSE. One 10/100/1000Base-T RJ-45 or 2-Wire Terminal Block Combo Port and one 10/100/1000Base-T IEEE 802.3af/at or one100/1000Base-X SFP Combo Port; PD and PSE for connected IP device. Optional 90W Industrial Power Supply provides power for Local Unit and can be used optionally at the Remote Unit for redundant power. 90 ~ 264 VAC; 127 ~ 370 VDC. (Sold separately; country specific power cord included.) Optional 4-Slot Media Converter Shelf Optional 4″ Wall Mount Kit (long); sold separately. Optional 5" [127 mm] DIN Rail Mount Bracket; sold separately. Optional 3.3" [84 mm] DIN Rail Mount Bracket (flat); sold separately. Optional 5" [127 mm] Vertical Mount; sold separately. Note: Extenders must be used as a pair, with one Local Unit and one Remote Unit required. A properly isolated power source is required for each Local Unit and an external power supply is optional for Remote Units depending on power requirements. 33706 Rev. F EO2P User Guide |Page 4