Lantronix MSSLite MSS Reference Manual - Page 22
Change Autostart
View all Lantronix MSSLite manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Change Autostart Command Reference Note: Defaults See Also In the absence of the Portlist parameter, the configuration will affect the MSS4's current port only. PortList Specify a particular port or group of ports. Port numbers are specified with integers between 1 and 4, and should be separated with commas (for lists) or dashes (for ranges). Disabled Change Autostart, page 2-12; Change Charsize, page 2-16; Change Parity, page 2-35. 2.5 Change Autostart DISABLED ENABLED CHARACTER x ANY y CHANGE PORT PortList AUTOSTART NONE ANY 1 SAVE 2 NONE Determines whether the specified port will wait for a carriage return or pre-set character(s) before starting a connection. Enabling Autostart causes the port to start connections automatically. Autostart can also be configured to allow a user-defined sequence of one or two characters to initiate sessions. If the port is in Dedicated mode, the autostart characters can be sent to the host as the first bytes of data. In all other modes, autostart characters are discarded. Restrictions Requires privileged user status. Errors Autostart and Autobaud are incompatible. If the port is set for Autobaud, enabling Autostart will disable Autobaud and produce an error message. The Save parameter is only applicable when the port is configured with a dedicated host. If Modem Control is enabled, a port enabled for autostart will not be idle unless DSR is held low, and therefore will not be available for connections from the network. Parameters Port MSS4 only. Specifies a particular port or group of ports. Note: In the absence of the Portlist parameter, the configuration will affect the MSS4's current port only. 2-12