Lantronix S3220 Series User Guide Rev J PDF 34.75 MB - Page 458

Transition Networks ION x222x / x32xx User Guide Message: SNMP user name length should be shorter than 32! This user already exists! Meaning: The user already exists or you entered too many characters (32 characters maximum) for the SNMP User Name. (The SNMP user's security model can only be v3.) Recovery: 1) Re-enter the command with a unique user name, IP address, and Port number. 2) Make sure the user name entered has less than 32 characters in it. 3) Make sure the SNMP user's security model is v3. 4) Verify the command syntax and re-enter the command. See the related section of the manual for specifics. 5) Try using the ION Web interface to perform the function. 6) If the problem persists, contact TN Tech Support. See Contact Us below. Message: ERROR Software version of this card ("cardVersion") is not supported, please upgrade to the same version as the IONMM Getting card version failed The failure get template config handler was called. Meaning: You attempted a function that is not supported by this version of firmware. Recovery: 1) Enter another (supported) function at this card's firmware version, or use the "go" command to switch to another card. 2) Upgrade to a newer firmware version. See "TFTP Transfer / Upgrade Commands" on page 204 or "Upgrade / Update Firmware Commands" on page 207. 3) Retry the operation. 4) If the problem persists, contact Technical Support. See Contact Us below. Message: The confirm password is not identical with the password! The user name length must be in range [1..64]! The user name must begin with an alphanumeric char! You can only change your own password, not others! Meaning: You entered a command to create a new system user, but the command failed. Recovery: 1) Verify the command syntax ("add sysuser name=NAMESTR level=(admin|read-write|read-only) pass=PASSSTR confirmpass=PASSSTR"). 2) Retry the operation, making sure the "pass" and "confirmpass" entries match. See the related command section. 3) If the problem persists, contact Technical Support. See Contact Us below. Message: Invalid input of timout value! Meaning: You set an unsupported SNMP trap timeout boundary value. Recovery: 1) In the "add snmp traphost" command, specify a valid timeout (-15s%-16s%-5u%-30s%-16s%-12s%12u%-12u%s (change from 8u to 12us). For example: C1|S1|L1D>add snmp traphost version v3 type ipv4 addr 192.168.1.30 port 162 security_name TrpHstA6 security_level authPriv notify trap timeout=] C1|S1|L1D>add snmp traphost version v3 type ipv4 addr 192.168.1.30 port 162 security_name TrpHstA6 security_level authPriv notify trap timeout 1000 retry 25 Problem: An SNMP user cannot access the IONMM. Meaning: The User security level is not compatible with the Group level. For example, you added an SNMPv3 User to a SNMP v1 Group, or added a User to a non-existing Group, so this user can not access the IONMM. Recovery: 1) Make sure the Group exists. Verify the User's security level. See the "Configure SNMP" section for specific details. Problem: Can't assign a SNMPv3 User to multiple Groups. Meaning: The SNMPv3 standards do not allow you to assign a SNMPv3 user to multiple groups. Recovery: 1) Create an additional, unique user. 2) Assign the new user to a different group. 3) Make sure that each user belongs to just one group. 33472 Rev. J https://www.transition.com Page 458 of 700