Lantronix TN-QSFP-100G Series TN-QSFP-100G User Guide Rev C - Page 6
Optical Specifications, Applications: Fiber Connections with SFPs, SFP Unpacking, SFP Installation
View all Lantronix TN-QSFP-100G Series manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Lantronix TN-QSFP-100G-xxxxx User Guide Optical Specifications The Optical Spec for all Lantronix SFPs are listed at www.transition.com/sfp.pdf. Applications: Fiber Connections with SFPs SFP applications include 100G Data Center connectivity, 100G Aggregation and Backplane applications, 100Gbase-X Ethernet, etc. The TN-QSFP-100G-CWDM4 can be used in a 100G CWDM4 application with FEC. SFP Unpacking Before you start installing the TN-QSFP-100G-xxxxx, verify that the package contains these items: o One TN-QSFP-100G-xxxxx o One Documentation Postcard Please notify your sales representative immediately if any of the above items is missing or damaged. Save the packaging for possible future use. SFP Installation Cautions • The SFP tranceiver module is keyed to only be installed one way. However, if forced the wrong way, damage may occur. • Avoid getting dust or other contaminants into the fiber bore of the SFP transceiver module, as this will cause the optics to not operate properly. • Clean the optic surfaces of the optical fiber before you plug them back in to the optical bores of another SFP tranceiver module. • Each port must match the wavelength specifications on the other end of the cable, and the cable must not exceed the specified cable length for reliable communications. Installing the TN-QSFP-100G-xxxxx The TN-QSFP-100G-xxxxx is used primarily in short reach applications in switches, routers, and data center equipment where it provides higher density than SFP+ modules. Note: The multiple-fiber push-on (MPO) connectors and the duplex LC connectors on the TN-QSFP100G-xxxxx support network interface cables with either Physical contact (PC) or Ultra-Physical Contact (UPC) flat-polished face types. The MPO connectors and the duplex LC connectors on the TN-QSFP100G-xxxxx do not support network interface cables with an angle-polished contact (APC) face type. Warning: Invisible laser radiation may be emitted from the aperture of the port when no cable is connected; avoid exposure to laser radiation and do not stare into open apertures. Warning: Ultimate disposal of this product must be handled according to all national laws and regulations. Warning: Use of controls, adjustments, or performing procedures other than those specified may result in hazardous radiation exposure. 33765 Rev. C http://www.lantronix.com/ Page 6 of 15