Lantronix TN-QSFP-100G Series TN-QSFP-100G User Guide Rev C - Page 7

Lantronix TN-QSFP-100G-xxxxx User Guide Tools Needed These tools are needed to install the TN-QSFP-100G-xxxxx: • Wrist strap or other personal grounding device to prevent ESD occurrences. • Antistatic mat or antistatic foam to set the TN-QSFP-100G-xxxxx on. • Fiber-optic end-face cleaning tools and inspection equipment. Installation Procedure Caution: The TN-QSFP-100G-xxxxx is a static-sensitive device. Always use an ESD wrist strap or similar individual grounding device when handling or coming into contact with a TN-QSFP-100G-xxxxx. The TN-QSFP-100G-xxxxx has a bail-clasp latch. To install a TN-QSFP-100G-xxxxx, follow these steps: 1. Attach an ESD wrist strap to yourself and a properly grounded point on the chassis or the rack. 2. Remove the TN-QSFP-100G-xxxxx from its protective packaging. 3. Check the label on the TN-QSFP-100G-xxxxx body to verify that you have the correct model for your network. 4. Remove the optical bore dust plug and set it aside. 5. Keep the bail-clasp aligned in a vertical position. 6. Align the TN-QSFP-100G-xxxxx in front of the module's transceiver socket opening and carefully slide the TN-QSFP-100G-xxxxx into the socket until the TN-QSFP-100G-xxxxx makes contact with the socket electrical connector. 7. Press firmly on the front of the TN-QSFP-100G-xxxxx with your thumb to fully seat the TN-QSFP100G-xxxxx in the TN-QSFP-100G-xxxxx socket. Caution: If the latch is not fully engaged, you could accidently disconnect the TN-QSFP-100G-xxxxx. 8. Reinstall the dust plug into the TN-QSFP-100G-xxxxx optical bore until you are ready to attach the network interface cable. Do not remove the dust plug until you are ready to attach the network interface cable. Label side top of SFP module Bale Clasp SFP Module Switch Triangle indicates bottom of SFP cage Fully Inserted SFP Switch 33765 Rev. C http://www.lantronix.com/ Page 7 of 15