Lantronix xPico xPico - Development Kit Quick Start

Lantronix xPico Manual

Get Lantronix xPico PDF manuals and user guides View all Lantronix xPico manuals
Add to My Manuals
Save this manual to your list of manuals

Lantronix xPico manual content summary:

  • Lantronix xPico | xPico - Development Kit Quick Start - Page 1
    xPico Development Kit Quick Start Part Number 900-623 Revision C March 2013
  • Lantronix xPico | xPico - Development Kit Quick Start - Page 2
    , go to the Lantronix web site at www.lantronix.com/about/contact. Revision History Date April 2012 August 2012 March 2013 Rev. A B C Comments Initial release. Updated for the new revision of the evaluation board. Updated for the new xPico Modbus module. xPico Development Kit Quick Start 2
  • Lantronix xPico | xPico - Development Kit Quick Start - Page 3
    Need to Know 4 Hardware Address 4 IP Address 4 Connecting an xPico Module - Network Method 5 Connecting an xPico Module - Serial Method 6 Install DeviceInstaller 6 Assign an IP Address 7 Configure Your xPico Device 9 xPico Module 9 xPico-IAP Module 9 xPico Development Kit Quick Start 3
  • Lantronix xPico | xPico - Development Kit Quick Start - Page 4
    Introduction Thank you for purchasing the xPico Development Kit from Lantronix. This Quick Start guide describes the procedures for initial connection to the xPico module through either a network connection or serial port. Once a connection is established you can use the WebManager or Setup Mode for
  • Lantronix xPico | xPico - Development Kit Quick Start - Page 5
    the power supply to the Evaluation Board. 4. Move the power switch on the Evaluation Board to ON. This is the last step in 'connection.' The xPico is ready for configuration. 5. Continue with Install DeviceInstaller on page 6. xPico Development Kit Quick Start 5
  • Lantronix xPico | xPico - Development Kit Quick Start - Page 6
    or higher. 1. Download the latest version of DeviceInstaller from www.lantronix.com/downloads. 2. Run the executable to start the installation process. 3. Respond to the installation wizard prompts. (If prompted to select an installation type, select Typical.) xPico Development Kit Quick Start 6
  • Lantronix xPico | xPico - Development Kit Quick Start - Page 7
    of Lantronix device servers on the local network. (In case no DHCP server is available, it can take 30 seconds before an AutoIP address is generated and the unit is detectable). 3. Click the Assign IP icon . 4. Select Assign a specific IP address and click Next. xPico Development Kit Quick Start
  • Lantronix xPico | xPico - Development Kit Quick Start - Page 8
    7. Click Assign and wait several seconds until a confirmation message appears. 8. Click Finish. 9. Select the xPico from the main window list and click ToolsPing. The results appear in the Status area. 10. network segment you are working with. 11. Click Close. xPico Development Kit Quick Start 8
  • Lantronix xPico | xPico - Development Kit Quick Start - Page 9
    xPico Module From DeviceInstaller it is easy to start the Lantronix browser-based tool, "Web Manager" to configure the xPico. For detailed information on Web Manager configuration and on other methods, see the xPico User Guide the xPico. xPico-IAP Module From xPico Development Kit Quick Start 9
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
xPico
Development Kit
Quick Start
Part Number 900-623
Revision C March 2013