Lantronix xPico xPico - Development Kit Quick Start - Page 5
Connecting an xPico Module — Network Method, IP Address, Subnet Mask, Gateway
View all Lantronix xPico manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
IP Address Subnet Mask Gateway Connecting an xPico Module - Network Method A network connection, if the equipment is available, is the preferred method for the initial configuration of the xPico. Note: Before wiring and powering on the xPico Evaluation Board please make sure that the correct xPico module for your needs is fitted. Removing and inserting the xPico module is quite simple and requires removing the fitted mounting clip and exchanging the module in the 40-pin socket. 1. Connect the PC to the Evaluation Board with a cross-over cable or a hub/switch and two RJ45 cables. Make sure there is no router between the PC and the Evaluation Board. 2. Select the appropriate power plug adaptor for your geographical location. Insert it into the slot on the Universal Power Supply; then plug the power supply into an outlet. 3. Connect the output plug of the power supply to the Evaluation Board. 4. Move the power switch on the Evaluation Board to ON. This is the last step in 'connection.' The xPico is ready for configuration. 5. Continue with Install DeviceInstaller on page 6. xPico Development Kit Quick Start 5