Lantronix xPico xPico - Development Kit Quick Start - Page 8
Assign, Finish, Tools, Clear Status, Close
View all Lantronix xPico manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. Enter the IP address. The Subnet mask appears automatically based on the IP address. You may change it. On a local network, you can leave the Default gateway blank (all zeros). 6. Click Next. 7. Click Assign and wait several seconds until a confirmation message appears. 8. Click Finish. 9. Select the xPico from the main window list and click ToolsPing. The results appear in the Status area. 10. Click Clear Status to clear the window to ping the device again. Note: If you do not receive "Reply" messages, ensure the IP address assigned is valid for the particular network segment you are working with. 11. Click Close. xPico Development Kit Quick Start 8
5. Enter the IP address.
The Subnet mask appears automatically based on the IP address.
You may change it. On a local network, you can leave the Default gateway
blank (all zeros).
6. Click
Next
.
7. Click
Assign
and wait several seconds until a confirmation message
appears.
8. Click
Finish
.
9.
Select the xPico from the main window list and click
Tools
Ping
. The
results appear in the Status area.
10. Click
Clear Status
to clear the window to ping the device again.
Note:
If you do not receive “Reply” messages, ensure the IP address assigned is
valid for the particular network segment you are working with.
11. Click
Close
.
xPico Development Kit Quick Start
8