Lenovo H420 Lenovo H4 Series Hardware Replacement Guide V1.0 - Page 19

Replacing an optical drive

Get Lenovo H420 PDF manuals and user guides View all Lenovo H420 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

3. Remove the four screws that secure the hard disk drive to drive bay. 4. Remove the hard disk drive by pulling it straight out of the drive bay. 5. Slide the new hard disk drive into the drive bay. 6. Secure the new hard disk drive to the drive bay with the four screws. 7. Connect the power and data cables to the hard disk drive. Refer to "Identifying parts on the system board". 8. Refer to "Completing the installation". Replacing an optical drive Attention: Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com To replace an optical drive 1. Remove the computer cover. Refer to "Removing the computer cover". 2. Remove the front bezel. Refer to "Removing and replacing the front bezel". 3. Disconnect the data and power cables from the rear of the optical drive. 4. Remove the two screws that secure the optical drive to drive bay. 16 Hardware Replacement Guide 31045292_H4_HRG_EN_V1.0.indd 16 2010.9.19 11:11:25 AM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
±¶
Hardware Replacement Guide
3. Remove the four screws that secure the hard disk drive to drive bay.
4. Remove the hard disk drive by pulling it straight out of the drive bay.
5. Slide the new hard disk drive into the drive bay.
6.
Secure the new hard disk drive to the drive bay with the four screws.
7. Connect the power and data cables to the hard disk drive. Refer to “Identifying
parts on the system board”.
8.
Refer to “Completing the installation”.
Replacing an optical drive
Attention:
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the
Safety and Warranty Guide
that was
included with your computer or in the
Hardware Maintenance Manual
(HMM)
for the computer. To obtain copies of the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at http://consumersupport.lenovo.com
To replace an optical drive
1.
Remove the computer cover. Refer to “Removing the computer cover”.
2.
Remove the front bezel. Refer to “Removing and replacing the front bezel”.
3.
Disconnect the data and power cables from the rear of the optical drive.
4.
Remove the two screws that secure the optical drive to drive bay.
31045292_H4_HRG_EN_V1.0.indd
16
2010.9.19
11:11:25 AM