Lenovo K4450 Laptop Hardware Maintenance Manual - Lenovo K4450 and K4450A - Page 73
Detachtheconnector, Loosenthescrews, withacomponent., Removal steps of the thermal module assembly
View all Lenovo K4450 Laptop manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Removal steps of the thermal module assembly Detach the connector 1 . Loosen the screws 2 to 7 . 3 4 5 2 7 6 1 When installing: Ensure that the connector is attached firmly to the system board. Carefully remove the thermal module assembly. Note: Be careful not to damage the connector. 8 When installing: Before you attach the thermal module assembly to the system board, apply thermal grease, at an amount of 0.2 grams, on the part marked a and b as shown in the following illustrations. Either too much or too less application of grease can cause a thermal problem due to imperfect contact with a component. Chapter 8. Removing or replacing a FRU 67
Removal steps of the thermal module assembly
Detachtheconnector
1
.Loosenthescrews
2
to
7
.
1
3
5
4
2
7
6
When installing:
Ensurethattheconnectorisattachedfirmlytothesystemboard.
Carefullyremovethethermalmoduleassembly.
Note:
Becarefulnottodamagetheconnector.
8
When installing:
Beforeyouattachthethermalmoduleassemblytothesystemboard,applythermal
grease,atanamountof0.2grams,onthepartmarked
a
and
b
asshowninthefollowingillustrations.
Eithertoomuchortoolessapplicationofgreasecancauseathermalproblemduetoimperfectcontact
withacomponent.
Chapter 8
.
Removing or replacing a FRU
67