Lenovo ThinkCentre A58 Hardware Maintenance Manual - Page 73
IDE signal cable
View all Lenovo ThinkCentre A58 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Diagnostic error code 018-250-XXX PCI Card Services error 020-000-XXX PCI Interface Test Passed 020-0XX-XXX PCI Interface error 020-195-XXX PCI Test aborted by user 020-196-XXX PCI test halt, error threshold exceeded 020-197-XXX PCI test warning 020-198-XXX PCI test aborted 020-199-XXX PCI test failed, cause unknown 020-262-XXX PCI system error 025-000-XXX IDE interface Test Passed 025-00X-XXX 025-01X-XXX IDE interface failure FRU/Action 1. PCI card 2. Riser card, if installed 3. System board No action 1. PCI card 2. Riser card, if installed 3. System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 51 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 51 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 134 3. Go to "Undetermined problems" on page 82 1. Go to "Undetermined problems" on page 82 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 134 3. Replace component under function test 1. PCI card 2. Riser card, if installed 3. System board No action 1. IDE signal cable 2. Check power supply voltages 3. Reseat IDE signal cable 4. IDE device 5. System board Chapter 7. Symptom-to-FRU index 67