LevelOne HVE-6601T Quick Install Guide - Page 3

Quick Installation on HVE-6501 :  HVE-6501T Transmitter 1. DC5V or PoE: Connect it to the external AC adapter which plugs into an electrical outlet. Or via 802.3af PoE PSE to GIGA LAN port. 2. GIGA LAN: Connect directly to a Receiver or to a Gigabit IGMP Ethernet Switch using CAT5e/6 cable. 3. HDMI IN: Connect to an HDMI source device with an HDMI M-M cable. Use an HDMI --> DVI adapter if the source is DVI. LEDs , Button and Group ID setting 1. POWER LED Blinking: power on and the unit is booting up. 2. POWER LED On: power on and the unit is active. 3. LINK LED Off: LAN is not connected. 4. LINK LED On: LAN is connected. 5. DATA LED Blinking: if Transmitter is connecting with LAN, or the HDMI source is removed. 6. DATA LED On: All the connections are working. 7. RESET Button: change Link / Unlink; Engineering Mode and Reset to default using this button. Please to see the RESET Button Descriptions. 8. GROUP ID: Set up the Transmitter's group ID by adjusting the 4-pin DIP switch, ON means "1", OFF means "0", there are 16 groups available to set up. Multicast IP Address 255.0.0.XXX & 255.0.1.XXX, the XXX are resolved by the 4-pin DIP Switch on the Transmitter. Page3