LevelOne HVE-6601T Quick Install Guide - Page 5

Quick Installation on HVE-6601 :  HVE-6601T Transmitter (Video Wall) 1. DC5V/PoE: Connect it to the external AC adapter which plugs into an electrical outlet. Or via 802.3af PoE PSE to GIGA LAN port. 2. GIGA LAN: Connect directly to a Receiver or to a Gigabit IGMP Ethernet Switch using CAT5e/6 cable. 3. HDMI IN: Connect to an HDMI source device via HDMI splitter (optional) with an HDMI M-M cable. 4. RS-232: Used Y Cable to separate S0(RS-232 port) and S1(Debug console port) for Video Wall system solutions.  P1(DB9P-M): Connect to RS232 port of HVE-6601T.  P2(DB9P-F)(S0): Connect to next HVE-6601T's P3(S1) of Y cable.  P3(DB9P-M) (S1): Connect to previous HVE-6601T's P2(S0) of Y cable. LEDs , button and Group ID setting 1. POWER LED Blinking: power on and the unit is booting up. 2. POWER LED On: power on and the unit is active. 3. LINK LED Off: LAN is not connected. 4. LINK LED On: LAN is connected. 5. DATA LED Blinking: if Transmitter is connecting with LAN, or the HDMI source is removed. 6. DATA LED On: All the connections are working. 7. PB : change Link / Unlink; Engineering Mode and Reset to default using this button. Please to see the Push Button Descriptions. 8. GROUP ID: Set up the Transmitter's group ID by adjusting the 4-pin DIP switch, ON means "1", OFF means "0", there are 16 groups available to set up. Multicast IP Address 255.0.0.XXX & 255.0.1.XXX, the XXX are resolved by the 4-pin DIP Switch on the Transmitter. Page5