Lexmark 15W0335 User's Guide - Page 91

13 Close the top door. Replacing the fuser and air filter kit Your printer monitors the life of your fuser. When the fuser reaches the end of its life, the printer displays 87 Fuser Exhausted. It is time for you to replace the fuser kit. The fuser kit consists of a fuser and air filter. For best print quality, make sure you replace the air filter when you replace your fuser. The air filter removes excess dust and other contaminants from the printer. Press Go to clear the message. The Supplies message appears on the second line of the display to remind you that supplies need attention. If the top door is opened and closed, the message Did you replace Fuser? appears. If a new fuser and air filter have not been installed, press Stop. If a new fuser and air filter have been installed, press Go. If you install a new fuser and air filter before the 87 Fuser Exhausted message appeared, you must manually reset the fuser counter. For more information, see reset the fuser counter. To replace the fuser and air filter kit components, use the following steps or the instruction sheet supplied with the fuser and air filter kit: WARNING: It takes approximately 30 minutes for the oil to reach the fuser after oil bottle installation. Make sure the oil bottle has been installed for at least 30 minutes before printing. 91