Lexmark C950 Service Manual - Page 52

5058-030 User status and attendance messages User primary message Explanation Change [paper source] to [paper size] [paper type] Change [paper source] to [paper size] [paper type] load [orientation] Check [src] orientation or guides Try one or more of the following: • Touch Use current [paper source] to ignore the message and print from the selected tray. • Load the correct paper size and type in the tray, verify the paper size and type settings are specified in the printer control panel Paper menu, and then touch Paper changed, continue. • Touch Cancel job to cancel the print job. Try one or more of the following: • Touch Use current [paper source] to ignore the message and print from the selected tray. • Load the correct paper size and type in the tray, verify the paper size and type settings are specified in the printer control panel Paper menu, and then touch Paper changed, continue. • Touch Cancel job to cancel the print job. Try one or more of the following: • Move the paper guides in the tray to the correct positions for the paper size loaded. • Make sure the paper size setting matches the paper loaded in the tray: 1. From the printer control panel Paper menu, check the Paper Size setting. 2. Before sending the print job, specify the correct size setting: - For Windows users, specify the paper size from Print Properties. - For Macintosh users, specify the paper size from the Page Setup dialog. Close cover [x] Close the specified cover to clear the message. Close door [x] Close the specified door. Disk corrupted Empty the hole punch box The printer attempted a hard disk recovery on a corrupted hard disk, and the hard disk cannot be repaired. The hard disk must be reformatted. Touch Format disk to reformat the printer hard disk and clear the message. Note: Formatting deletes all the files stored on the printer hard disk. 1. Empty the hole punch box. For instructions on emptying the hole punch box, from the printer control panel touch More Information. 2. Reinsert the hole punch box into the finisher, and then touch Continue to clear the message. Error reading USB drive. Remove USB. An unsupported USB device has been inserted. Remove the USB device, and then install a supported one. Insert staple cartridge Insert Tray [x] Try one or more of the following: • Install a staple cartridge. • Touch Continue to clear the message and print without using the staple finisher. Insert the specified tray into the printer. Insert the hole punch box Insert the hole punch box into the finisher, and then touch Continue to clear the message. Install Tray [x] Try one or more of the following: • Install the specified tray: 1.Turn the printer off. 2.Unplug the power cord from the wall outlet. 3.Install the specified tray. 4.Connect the power cord to a properly grounded electrical outlet. 5.Turn the printer back on. • Cancel the print job. Previous Next Go Back 2-4 Service Manual