Lexmark C950 Service Manual - Page 694

5058-030 12. Remove the belt (buffer/transport) (F) from the buffer roll drive gear 46T (G). C G E E-clip E Second F D H First 13. Use a prying tool to remove the e-clip securing the buffer roll drive gear 23/53T (G). 14. Remove the buffer roll drive gear 53/23T (G). 15. Release the hook of the buffer roll drive gear 46T (H) from the buffer roll assembly (C). 16. Remove the buffer roll drive gear 46T (H). 17. Remove the 6 mm bushing (D). 18. Remove the buffer roll assembly (C) from inside the finisher. Note: When removing the buffer roll assembly (C), do not touch the rubber surface. Replacement notes: • Make sure the flat spot on the end of the buffer roll assembly (C) is installed to the rear. Previous Next Go Back C Front • When replacing the buffer roll assembly, do not touch the rubber surface. • The tension of the belt (buffer/transport) (F) is automatically adjusted by the force of the spring attached to the belt tensioner bracket (E). • Tighten the two screws in the order shown. 4-274 Service Manual