Lexmark CX942 Users Guide - Page 223
Finishing, Setup, Staple Job, Staple Test, Hole Punch, Hole Punch Mode, Notes, Offset s
View all Lexmark CX942 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 223 highlights
Use printer menus 223 Finishing Menu item Description Staple Job Off* 1 staple, top left corner 2 staples, left 1 staple, top right corner 2 staples, top 1 staple, bottom left corner 2 staples, bottom 1 staple, bottom right corner 2 staples, right Specify the staple position for all print jobs. Note: This menu item appears only when a staple finisher is installed. Staple Test Start Determine whether the staple finisher is functioning properly. Note: This menu item appears only when a staple finisher is installed. Hole Punch Off* On Punch holes along the edge of the printed output. Note: This menu item appears only when a staple, hole punch finisher is installed. Hole Punch Mode 2 holes 3 holes 4 holes Set the hole punch mode for the printed output. Notes: • 3 holes is the U.S. factory default setting. 4 holes is the international factory default setting. • This menu item appears only when a staple, hole punch finisher is installed. Offset Pages None* Between Copies Between Jobs Offset the output of each print job or each copy of a print job. Notes: • Between Copies offsets each copy of a print job if Collate is set to On [1,2,1,2,1,2]. If Collate is set to Off [1,1,1,2,2,2], then each set of printed pages is offset, such as all pages designated as 1 and all pages designated as 2. • Between Jobs sets the same offset position for the entire print job regardless of the number of copies printed. Note: An asterisk (*) next to a value indicates the factory default setting. Setup Menu item Description Printer Language PCL Emulation PS Emulation* Set the printer language. Note: Setting a printer language default does not prevent a software program from sending print jobs that use another printer language. Note: An asterisk (*) next to a value indicates the factory default setting.