Lexmark E352DN Service Manual - Page 91
Cover open sensor removal
View all Lexmark E352DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
4512-420, -430 Cover open sensor removal 1. Remove Tray 1. 2. Open the front cover. 3. Open the right side cover. See steps 1 and 2 of "Right side cover removal" on page 4-5. 4. Remove the controller card cover. 5. Loosen the one screw (A) from the shield that protects the sensor. 6. Disconnect the cable from J6 on the controller card. Note: The cable has a toroid. Be sure to remove the toroid before removing the cable. 7. Use a small Phillips screwdriver to remove the screw (B) holding the sensor. 8. Remove the sensor. Reinstallation note: • Be sure to re-route the cable back through its retainer. • Be sure to place the toroid back over the cable. Repair information 4-15
Repair information
4-15
4512-420, -430
Cover open sensor removal
1.
Remove Tray 1.
2.
Open the front cover.
3.
Open the right side cover. See steps 1 and 2 of
“Right side cover removal” on page 4-5
.
4.
Remove the controller card cover.
5.
Loosen the one screw (A) from the shield that protects the sensor.
6.
Disconnect the cable from J6 on the controller card.
Note:
The cable has a toroid. Be sure to remove the toroid before removing the cable.
7.
Use a small Phillips screwdriver to remove the screw (B) holding the sensor.
8.
Remove the sensor.
Reinstallation note
:
•
Be sure to re-route the cable back through its retainer.
•
Be sure to place the toroid back over the cable.