Lexmark MS510 Forms and Bar Code Card Technical Reference Guide - Page 29
Intelligent Mail bar code, Notes
View all Lexmark MS510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Field Name Type Esc(s#1,#2,#3,#4S int Esc(s#P int Range Minimum: Minimum value is 1, but symbol may be too small to be readable. Maximum: There is no maximum value but larger values produce a symbol that may not fit on the page. 0=Default 1=No HRT 2=Embedded 3=Half-Embedded 4=Under Default (if not specified) 8,16,24,32 (dec) or 8,10,18,20 (hex) 0 (dec) or 00 (dec) Description Optional Selects the width of the spaces. Optional Defines the HRT Location. Note: HRT is not available on RSS-14 Stacked. Notes: • The default V parameter observed for the HP BarDIMM Pro version 3.3A is: - Standard: 32 (11 mm) - Truncated: 12 (4 mm) - Stacked: 13 (4 mm total height) - Limited: 10 (3 mm) • Some of the Forms and Bar Code Card default V parameter values (in the above table) are slightly different than HP, and match the RSS-14 AIM specification values. • Each of the V parameter values is considered in the RSS-14 AIM specification as a multiple of "X", which is a "module width", assumed to be 1 by the bar code engine. • Only the value for Bar Width 1 is needed for the design of the 2D add-on. All other bar widths are dependent on the value of Bar Width 1. • The S parameter does not work correctly on HP BarDIMM and Forms and Bar Code Card. Setting S1 to any value does not affect the bar code like it does with B1. The S parameter should vary the whitespace widths on the Forms and Bar Code Card like it does on other one-dimensional bar codes. Intelligent Mail bar code Intelligent Mail bar code is used by the Postal Service to sort and track letters and flats. It combines data from the POSTNET bar code and the PLANET code into a single bar code. Intelligent Mail bar code is also referred to as OneCode, IMB, or 4-State bar code. One-dimensional bar codes 29