Lexmark Optra S Service Manual - Page 133
HVPS - 917 Error Code, Left Transfer Arm Assembly
View all Lexmark Optra S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
4059-XXX FRU 2 Left Transfer Arm Assembly 3 Right Transfer Arm Assembly 4 HVPS - 917 Error Code Action Check the left transfer roll arm assembly to make sure it is fastened and locked in the down position. If the arm is not locked down, check to ensure the arm is not broken and will lock into the EP frame correctly. Check the left transfer arm assembly spring for proper operation. Check the right transfer arm assembly to make sure it is fastened and locked in the down position. If the arm is not locked down, check to make sure the arm is not broken and will lock into the EP frame correctly. Check the right transfer arm assembly spring for proper operation. For any background problems, check to ensure the contact to the HVPS board is correct and that there is approximately 0 ohms resistance between the transfer roll shaft and the HVPS contact. If correct, go to "Print Quality - Background" on page 2-96 Check the voltage at J10-3. The voltage changes from +24 V dc with the printer idle to 0 V dc when the printer runs the print test. If the voltage is incorrect, check the continuity of line J10-3 in the front cable harness to the HVPS. If there is no continuity, replace the cable harness. If there is continuity, replace the HVPS. If the problem continues, replace the engine board. Diagnostic Information 2-106