LiftMaster 81600 Owners Manual - English French Spanish - Page 27
Align the Safety Reversing Sensors, SAFETY SENSOR TROUBLESHOOTING
![]() |
View all LiftMaster 81600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Power 2 Align the Safety Reversing Sensors IMPORTANT: The safety reversing sensors MUST be connected and aligned correctly before the garage door opener will move in the down direction. When the garage door opener has power, check the safety reversing sensors. If the sensors are aligned and wired correctly, both LEDs will glow steadily. SAFETY SENSOR TROUBLESHOOTING If either of the sensor LEDs are off, there is no power to the sensor: 1. Check that you have power to the garage door opener. 2. Check the sensor wire is not shorted or broken. 1 2 3 Light Beam Protection Area Sending sensor - amber LED Receiving sensor - green LED The receiving sensor has a sticker on the back. To align the safety reversing sensors: 1. Loosen the wing nuts. 2. Adjust the sensors up or down until both LEDs glow steady indicating alignment. 3. Tighten the wing nut to secure the sensor. If the green receiving sensor LED is blinking, the sensors are obstructed or misaligned: 1. Check for obstructions in the sensor light beam. 2. Align the sensors. 3. If the receiving sensor (green LED) faces direct sunlight, switch the receiving sensor with the sending sensor and repeat 1 Install the Safety Reversing Sensors page 23 to assure proper operation. RED WHITE WHITE GREY Wing nut 27
![](/manual_guide/products/liftmaster-81602mc-owners-manual-english-french-spanish-1ad4019/27.png)