LiftMaster PPLX Installation Guide - Page 3
Wiring, Basic, Programming
View all LiftMaster PPLX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
WIRING MAGLOCK/STRIKE Use separate power supplies for the maglock/strike and the reader. AC/DC White/Black O MOV Maglock*/ White/Brown Strike I I piPower Supply 12 Vdc Power Supply Red + Black Black Brown Remote Open Normally Open ] Switch * Relay defaults to Normally Open. For Maglock, refer to Configure Relay Output in the Advanced Programming section. GATE/DOOR OPERATOR Use separate power supplies for the reader. Refer to page 2 for wiring details. White/Black O White/Brown Gate/Door i I M 12 Vdc Power Supply Red + Black Black Brown Remote Open Normally Open ] Switch BASIC PROGRAMMING PROGRAM INITIAL FACILITY CODE IMPORTANT: These steps MUST be completed in order to exit the initial programming mode. 1 Plug in the power supply to the reader (LED will flash Red/Green). 2 Present a Credential Device such as a Card to the reader to set the Facility Code (flashing will end in approximately 10 seconds). Credential Devices are pre-encoded and engraved at the factory with a Facility (Site) Code and an individual Credential Device ID number. Record the name of each person to whom a Credential Device is issued, as well as the ID number of their Credential Device.