LiftMaster RSL12V RSL12V Installation Manual - Page 22

PROGRAMMING » REMOTE CONTROLS + KEYLESS ENTRY + ERASE ALL CODES + ALTERNATE RADIO RECEIVER INSTALLATION A combined total of 50 remote controls and keyless entry PINs can be programmed to the operator. For highest level of security, we recommend the Security✚® line of products. Refer to Accessories. TO ADD OR REPROGRAM A REMOTE CONTROL (NOT PROVIDED) 1 Press and release the LEARN XMITTER button (LED will light). 2 Press the remote control button. The LED will flash and the alarm output will activate twice. To program additional remote controls, repeat the steps until all the remote controls are programmed. LEARN 1 XMITTER 2 TO ADD, REPROGRAM OR CHANGE A WIRELESS KEYLESS ENTRY PIN (NOT PROVIDED) 1 Press and release the LEARN XMITTER button (LED will light). 2 Enter a 4-digit personal identification number (PIN) of your choice on the keypad. 3 Press the ENTER button on the keypad. The LED will flash and the alarm output will activate twice. ERASE ALL CODES 1 Press and hold the LEARN XMITTER button on the control board until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ALTERNATE RADIO RECEIVER INSTALLATION 1 The receiver should be connected to the SINGLE BUTTON input and the CTRL PWR input. 21 1 LEARN XMITTER 2 PIN Number ?? ? ? 1 LEARN XMITTER OPEN CONTROL INPUTS SINGLE BUTTON RESET STOP CTRL PWR CTRL PWR 1