LiftMaster T T LOGIC VERSION 2 Manual - Page 13

Logic Control Ver. 2.0 1 Phase Wiring Diagram

Get LiftMaster T PDF manuals and user guides View all LiftMaster T manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

LOGIC CONTROL (VER. 2.0) 1 PHASE WIRING DIAGRAM 1837-1 230 VOLT MOTOR CONNECTION NOTE: CONTACTOR 1PH / 3 PH JUMPER SHOULD BE IN 1 PH POSITION 115 VOLT MOTOR CONNECTION Note: 1) See Owner's Manual for Dip Switch Functions and Programming Procedures 2) TO REVERSE MOTOR DIRECTION 115 VOLTS: ALWAYS EXCHANGE PURPLE & GRAY ALL VOLTS & PHASES. 230 VOLTS: INTERCHANGE PURPLE (E10) & GRAY (E15) WIRES AT LOGIC BOARD. * - BLUE WIRE MUST BE INSULATED ON 230V 1PH. **- Transformer Primary Voltage same as Line Voltage.. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
13
LOGIC CONTROL (VER. 2.0) 1 PHASE WIRING DIAGRAM
1837-1
115 VOLT MOTOR CONNECTION
230 VOLT MOTOR CONNECTION
Note:
1)
See Owner’s Manual for Dip Switch Functions and Programming Procedures
2)
TO REVERSE MOTOR DIRECTION
115 VOLTS:
ALWAYS EXCHANGE PURPLE & GRAYALL VOLTS & PHASES.
230 VOLTS:
INTERCHANGE PURPLE (E10) & GRAY (E15) WIRES AT LOGIC BOARD.
* - BLUE WIRE MUST
BE INSULATED ON 230V 1PH.
**- Transformer Primary Voltage same as Line Voltage..
NOTE:
CONTACTOR 1PH / 3 PH JUMPER
SHOULD BE IN 1 PH POSITION