Linksys PCMPC100U User Guide - Page 15

Instant EtherFast® Series 6. When the following window appears, click Finish. When you are asked if you want to restart your computer, remove any Driver Disks from the floppy disk drive, click Yes, and allow your system to restart. 7. After Windows restarts, enter a User Name and a Password when prompted, and click the OK button. 8. Once you are back on the Windows desktop, you can make the necessary changes to your system's network settings by clicking on the Start button, then Settings, then Control Panel, then double-click the Network icon. Note: Linksys does not provide technical support for TCP/IP configuration or troubleshooting. EtherFast® 10/100 PC Cards Windows NT 4.0 Installation and Setup Overview The following instructions will set up an NT 4.0 server/workstation on your PC. You should have your original Windows NT CD-ROM handy during the installation, as you might be asked to supply it. Note: Screen shots used in this Installation and Setup section are from installation of the standard EtherFast 10/100 PC Card (PCMPC100 v3). If you are installing the EtherFast 10/100 Integrated PC Card (PCM100 v3), the installation process will be unchanged, however, the product name will be different. To install the network driver for an NT 4.0 Server or Workstation 1. Log into Windows NT as a network administrator. 2. Click on Start, Settings, Control Panel, and then double-click on the Network icon. 3. If you have not previously installed Windows NT networking on your computer, a message will appear that reads: Windows NT Networking is not installed. Do you want to install it now? 9. When the above window is displayed, click on the Configuration tab. Confirm that all the following network components are installed: • Client for Microsoft Networks • Linksys EtherFast 10/100 PC Card (PCMPC100 V3) • TCP/IP To set up File and Printer Sharing, or to configure Client for Microsoft Networks or Client for Netware Networks, please refer to the Appendix. Your EtherFast card is now successfully set up. 24 • If you see this message, click Yes to install NT networking along with the EtherFast Card's network driver, and continue with step 1 below. • If you don't see this message, NT networking is already installed. Skip to the section entitled Installing the EtherFast Network Driver if Networking is Already Installed. Installing NT Networking & the EtherFast Card Driver 1. After clicking on Yes, the Network Setup Wizard window will appear. 2. Put a checkmark next to the Wired to the network option. Click Next. 25