Linksys SPA-841 Cisco SPA9000 Voice System Administration Guide - Page 110
Configuring a SPA400 to Interoperate with the SPA9000 - firmware update
View all Linksys SPA-841 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Administering the SPA400 and Voice Mail Service Configuring a SPA400 to Interoperate with the SPA9000 STEP 7 When the confirmation message appears, click OK. 5 STEP 8 When the Setup page reappears, verify that the Firmware Version number matches the firmware version that you installed. You have successfully upgraded the firmware. SPA400 Main Page: Firmware Version NOTE You may need to refresh your browser to display the updated banner reflecting the new version number. Configuring a SPA400 to Interoperate with the SPA9000 A SPA400 must be configured to register the SPA9000. To enable the interoperation of the two devices, you need to enter corresponding information on the SPA9000 Voice > Line page and on the SPA400 Setup > SPA9000 Interface page. For voice mail service, additional entries are needed on the SPA400 Setup > Voicemail Server page. Be aware of the following factors: • You need to complete this procedure for each SPA400, whether it is used as a PSTN gateway or as a voice mail server. • You need to configure a SPA9000 line interface for each SPA400. See "Configuring a Line Interface for a SPA400 (PSTN or Voice Mail)," on page 60. SPA9000 Voice System Administration Guide 108