Linksys SRW224P Cisco WAP200E Wireless-G Exterior Access Point with PoE Admini - Page 20

Chapter 6 Advanced Configuration Wireless > Wireless Connection Control This screen allows you to configure the Connection Control List to either permit or block specific wireless client devices connecting to (associating with) the Access Point. Wireless > Wireless Security > WEP Authentication Type Choose the 802.11 authentication type as either Open System or Shared Key. The default is Open System. Default Transmit Key Select the key to be used for data encryption. Encryption Select a level of WEP encryption, 64 bits (10 hex digits) or 128 bits (26 hex digits). Passphrase If you want to generate WEP keys using a Passphrase, then enter the Passphrase in the field provided and click the Generate key. Those auto-generated keys are not as strong as manual WEP keys. Key 1-4 If you want to manually enter WEP keys, then complete the fields provided. Each WEP key can consist of the letters "A" through "F" and the numbers "0" through "9". It should be 10 characters in length for 64-bit encryption or 26 characters in length for 128-bit encryption. Change these settings as described here and click Save Settings to apply your changes, or click Cancel Changes to cancel your changes. Help information is available on the right side of the screen. Disable There is no option to be configured for this mode. When you have finished making changes to the screen, click the Save Settings button to save the changes, or click the Cancel Changes button to undo your changes. Help information is available on the right side of the screen. Wireless > Wireless Connection Control Wireless Connection Control Select SSID Select the SSID of the wireless network that you want to use wireless connection control on. Enabled/Disabled Enable or disable wireless connection control. The default is disabled. Connection Control Allow only following MAC addresses to connect to wireless network When this option is selected, only devices with a MAC address specified in the Connection Control List can connect to the Access Point. Prevent following MAC addresses from connecting to wireless network When this option is selected, devices with a MAC address specified in the Connection Control List will not be allowed to connect to the Access Point. Wireless Client List Instead of manually entering the MAC addresses of each client, the Access Point provides a convenient way to select a specific client device from the client association table. Click this button and a window appears to let you select a MAC address from the table. The selected MAC address will be entered into the Connection Control List. Wireless-G Exterior Access Point with Power Over Ethernet 15