Linksys SRW224P Cisco WAP200E Wireless-G Exterior Access Point with PoE Admini - Page 9

Chapter 3 Product Overview Back Panel The Access Point's Reset button and ground are located on the back panel. Reset button The Antenna Pattern The Wireless-G Exterior Access Point uses 1X2 MIMO (1Tx, 2Rx) so it has two built‑in antennas. The right antenna is the main antenna for Tx traffic. When an external antenna is attached, the right antenna is disabled and the external antenna is used for Tx traffic. Currently, only the HGA9N (9dBi omni‑directional antenna) is compatible with the Wireless-G Exterior Access Point. Ground Back Panel Reset Button There are two ways to Reset the Access Point's factory defaults. Either press the Reset button, for approximately ten seconds, or restore the defaults using the Access Point's web-based utility. IMPORTANT: Resetting the Access Point will erase all of your settings (including wireless security, IP address, and power output) and replace them with the factory defaults. Do not reset the Access Point if you want to retain these settings. Ground Before you mount the Access Point, you must ground the Access Point (to a large piece of metal) as a precaution against electric shock. Wireless-G Exterior Access Point with Power Over Ethernet Right Antenna Pattern 3dB BW: 50 degree, peak gain: 6.3 dBi Left Antenna Pattern 3dB BW: 63 degree, peak gain: 4.9 dBi 4