Linksys WAP55AG User Guide - Page 30

Dual-Band Wireless A + G Access Point The Wireless Tab - Wireless MAC Filter Wireless network access can be filtered by using the MAC addresses of the wireless devices. Access Restrictions To filter wireless users by MAC Address, either permitting or blocking access, click Enabled. If you do not wish to filter users by MAC Address, select Disabled. Prevent PCs listed below from accessing the wireless network. Clicking this radio button will block wireless access by MAC Address. Permit PCs listed below to access the wireless network. Clicking this radio button will allow wireless access by MAC Address. Wireless Client List Wireless Client List. Click the Wireless Client List button to display a list of network users by MAC Address.From the To Sort by drop-down menu, you can sort the table by Client Name, Interface, IP Address, MAC Address, or Status. If you want to add any of the wireless clients to the Wireless MAC Filter List, then click the Save to Wireless Client List checkbox and then click the Save Settings button. Click the Cancel Changes button to cancel your changes. To view the most up-to-date information, click the Refresh button. To exit this screen, click the Close button. List users, by MAC Address, whose wireless access you want to control. Change these settings as described here and click the Save Settings button to apply your changes or Cancel Changes to cancel your changes. Help information is shown on the right-hand side of the screen. For additional information, click More. Figure 6-7: Wireless MAC Filter Chapter 6: Configuring the Dual-Band Wireless A + G Access Point The Wireless Tab - Wireless MAC Filter Figure 6-8: Wireless Client List 24