Linksys WAP55AG User Guide - Page 33
Frame Burst Mode, Enabled, Beacon Interval, DTIM Interval, Fragmentation Threshold, RTS Threshold
UPC - 745883553907
View all Linksys WAP55AG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Dual-Band Wireless A + G Access Point Frame Burst Mode. Enabling this option should provide your network with greater performance, depending on the manufacturer of your wireless products. If you are not sure how to use this option, keep the default, Enabled. Beacon Interval. The default value is 100. The Beacon Interval value indicates the frequency interval of the beacon. A beacon is a packet broadcast by the Access Point to synchronize the wireless network. DTIM Interval. This value indicates the interval of the Delivery Traffic Indication Message (DTIM). A DTIM field is a countdown field informing clients of the next window for listening to broadcast and multicast messages. When the Access Point has buffered broadcast or multicast messages for associated clients, it sends the next DTIM with a DTIM Interval value. Its clients hear the beacons and awaken to receive the broadcast and multicast messages. The default value is 1. Fragmentation Threshold. This value specifies the maximum size for a packet before data is fragmented into multiple packets. If you experience a high packet error rate, you may slightly increase the Fragmentation Threshold. Setting the Fragmentation Threshold too low may result in poor network performance. Only minor reduction of the default value is recommended. In most cases, it should remain at its default value of 2346. RTS Threshold. Should you encounter inconsistent data flow, only minor reduction of the default value, 2347, is recommended. If a network packet is smaller than the preset RTS threshold size, the RTS/CTS mechanism will not be enabled. The Access Point sends Request to Send (RTS) frames to a particular receiving station and negotiates the sending of a data frame. After receiving an RTS, the wireless station responds with a Clear to Send (CTS) frame to acknowledge the right to begin transmission. The RTS Threshold value should remain at its default value of 2347. Change these settings as described here and click the Save Settings button to apply your changes or Cancel Changes to cancel your changes. Help information is shown on the right-hand side of the screen. For additional information, click More. beacon internal: data transmitted on your wireless network that keeps the network synchronized packet: a unit of data sent over a network dtim: a message included in data packets that can increase wireless efficiency fragmentation: breaking a packet into smaller units when transmitting over a network rts (request to send): a networking method of coordinating large packets through the RTS Threshold setting. Chapter 6: Configuring the Dual-Band Wireless A + G Access Point 27 The Wireless Tab - Advanced Wireless Settings