Linksys WCM300 Cisco Cable Wideband Solution Design and Implementation Guide, - Page 50

Wideband CMTS Configuration Chapter 4 Implementing and Configuring the Solution All wideband channels used on a fiber node and all associated primary downstream channels on Cisco uBR10-MC5X20 cable interface line cards must be configured to belong to the same virtual bundle interface. For detailed information on this configuration task, see the "Configuring Wideband Channels and Primary Downstream Channels as Virtual Bundle Members" section in the Cisco uBR10012 Universal Broadband Router SIP and SPA Software Configuration Guide. Table 4-1 provides a list of the software configuration documents that are likely to be useful for configuring the Cisco Cable Wideband Solution, Release 1.0, base CMTS components. Table 4-1 Base CMTS Components Configuration: Where to Find Information Solution Component Cisco uBR10012 router (general and feature-specific configuration) Where to Find Information Release Notes for Cisco uBR10012 Universal Broadband Router for Cisco IOS Release 12.3 BC (which includes information on Cisco IOS Release 12.3(21)BC) Cisco uBR10012 Universal Broadband Router Software Configuration Guide Performance Routing Engine 2 (PRE2) Cisco uBR-MC5X20 line cards Cisco Cable Modem Termination System Feature Guide Route Processor Redundancy Plus for the Cisco uBR10012 Universal Broadband Router Chapter 3, "Configuring Cable Interface Features for the Cisco uBR10012 Router," in the Cisco uBR10012 Universal Broadband Router Software Configuration Guide "Cable Interface Bundling and Virtual Interface Bundling for the Cisco CMTS" in the Cisco Cable Modem Termination System Feature Guide Half-Height Gigabit Ethernet (HHGE) network uplink line cards "N+1 Redundancy for the Cisco Cable Modem Termination System" in the Cisco Cable Modem Termination System Feature Guide Configuring the Half-Height Gigabit Ethernet Line Card for the Cisco uBR10012 Universal Broadband Router The technical documentation set for the Cisco uBR10012 router includes many documents not shown in Table 4-1 that are useful for configuring this CMTS. The Cisco uBR10012 documentation set can be accessed from this web site area: http://www.cisco.com/en/US/products/hw/cable/ps2209/tsd_products_support_series_home.html Configuring Wideband CMTS Components The wideband CMTS components are added to the base CMTS components to make the CMTS wideband capable. This section provides overview information on configuring the wideband CMTS components: • Configuring the Wideband SIP and Wideband SPA, page 4-3 • Configuring the Edge QAM Device Configuration, page 4-3 • Configuring the Gigabit Ethernet Switch, page 4-5 Cisco Cable Wideband Solution Design and Implementation Guide, Release 1.0 4-2 OL-10705-02