Linksys WCM300 Cisco Cable Wideband Solution Design and Implementation Guide, - Page 61
Monitoring and Troubleshooting Wideband Components, Monitoring Wideband Components
![]() |
View all Linksys WCM300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
CH A P T E R 5 Monitoring and Troubleshooting Wideband Components This chapter provides an introduction to monitoring and troubleshooting the wideband components of the Cisco Cable Wideband Solution, Release 1.0. The chapter includes the following topics: • Monitoring Wideband Components, page 5-1 • Troubleshooting Wideband Components, page 5-13 Monitoring Wideband Components The Cisco IOS command-line interface includes commands that can be issued on the CMTS for the following: • Monitoring Wideband SIPs, page 5-2 • Monitoring Wideband SPAs, page 5-3 • Monitoring Wideband Channels, page 5-6 • Monitoring RF Channels, page 5-10 • Monitoring Wideband Cable Modems, page 5-10 For detailed information on the syntax, usage, and additional examples for each command, see the documents shown in Table 5-1. Note Many of the commands used to configure the Cisco uBR10012 router and the Cisco Wideband SIP and SPA are not currently part of the command set that can be searched with the Cisco Command Lookup Tool (available on Cisco.com). Use the documents listed in Table 5-1 to find information on these commands. Table 5-1 Wideband Command Reference Documentation Document Cisco uBR10012 Universal Broadband Router SIP and SPA Software Configuration Guide Command Described Commands for the Wideband SIP and Wideband SPA, including commands for RF and wideband channels OL-10705-02 Cisco Cable Wideband Solution Design and Implementation Guide, Release 1.0 5-1
![](/manual_guide/products/linksys-wcm300-cisco-cable-wideband-solution-design-implementation-guide-release-10-fullbook-pdf-15-mb-68f1dfc/61.png)