Linksys WRE54G Cisco WAP54GP Wireless-G Access Point with Power Over Ethernet - Page 32

WAP54GPE and Wireless-G Interior Access Point model number: WAP54GP., Wireless Repeater, Site Survey - repeater mode

Get Linksys WRE54G - Wireless-G Range Expander Repeater PDF manuals and user guides
UPC - 745883559046
View all Linksys WRE54G manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Wireless-G Access Point with Power Over Ethernet Wireless Repeater When set to Wireless Repeater mode, the Access Point receives the signal from the remote Access Point and retransmits its signal. (This feature only works with the Linksys Wireless-G Exterior Access Point (model number: WAP54GPE) and Wireless-G Interior Access Point (model number: WAP54GP). To configure a Wireless Repeater environment, click Wireless Repeater and enter the MAC addresses of the remote access points in the MAC fields. If you do not know an access point's MAC address, click the Site Survey button. Select the access points you want to use and click the Apply button. Then click the Close button to return to the AP Mode screen. If you do not see the access point you want, click the Refresh button to run another site survey. Chapter 6: Configuring the Wireless-G Access Point with Power Over Ethernet The AP Mode Tab Figure 6-17: Wireless Repeater 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
26
Chapter 6: Configuring the Wireless-G Access Point with Power Over Ethernet
The AP Mode Tab
Wireless-G Access Point with Power Over Ethernet
Wireless Repeater
When set to Wireless Repeater mode, the Access Point receives the signal from the remote Access Point and
retransmits its signal. (This feature only works with the Linksys Wireless-G Exterior Access Point (model number:
WAP54GPE) and Wireless-G Interior Access Point (model number: WAP54GP).
To configure a Wireless Repeater environment, click
Wireless Repeater
and enter the MAC addresses of the
remote access points in the
MAC
fields. If you do not know an access point’s MAC address, click the
Site Survey
button. Select the access points you want to use and click the
Apply
button. Then click the
Close
button to return
to the
AP Mode
screen. If you do not see the access point you want, click the
Refresh
button to run another site
survey.
Figure 6-17: Wireless Repeater