Lowrance Elite-5 Ti Installation Manual - Page 26

Wiring, Guidelines, serious injury may occur. Be sure that the voltage of - power cable

Get Lowrance Elite-5 Ti PDF manuals and user guides View all Lowrance Elite-5 Ti manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

5 Wiring Guidelines Don't do this: Don't make sharp bends in the cables. Don't run cables in a way that allows water to flow down into the connectors. Don't route the data cables in areas adjacent to radar, transmitter, or large current carrying cables. Do this: Do make drip and service loops. Do cable-tie all cables to keep them secure. Do solder/crimp and insulate all wiring connections, if extending or shortening power, NMEA 2000 (ELITE-7Ti only), or NMEA 0183 cables. Do leave room adjacent to connectors to ease plugging and unplugging of cables. Warning: Before starting the installation, be sure to turn electrical power off. If power is left on or turned on during the installation, fire, electrical shock, or other serious injury may occur. Be sure that the voltage of the power supply is compatible with the unit. Warning: The unit has a voltage rating of 12 V DC, it is not suited for use with 24 V DC systems. Warning: The positive supply wire (red) should always be connected to (+) DC with the supplied fuse or a circuit breaker (closest available to fuse rating). 26 Wiring | ELITE Ti Installation Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
Wiring
Guidelines
Don’t do this:
Do this:
Don’t make sharp bends in the
cables.
Do make drip and service loops.
Don’t run cables in a way that
allows water to flow down into
the connectors.
Do cable-tie all cables to keep
them secure.
Don’t route the data cables in
areas adjacent to radar,
transmitter, or large current
carrying cables.
Do solder/crimp and insulate all
wiring connections, if extending
or shortening power, NMEA
2000 (ELITE-7Ti only), or NMEA
0183 cables.
Do leave room adjacent to
connectors to ease plugging
and unplugging of cables.
Warning:
Before starting the installation, be sure to
turn electrical power off. If power is left on or turned on
during the installation, fire, electrical shock, or other
serious injury may occur. Be sure that the voltage of the
power supply is compatible with the unit.
Warning:
The unit has a voltage rating of 12 V DC, it
is not suited for use with 24 V DC systems.
Warning:
The positive supply wire (red) should
always be connected to (+) DC with the supplied fuse
or a circuit breaker (closest available to fuse rating).
5
26
Wiring
| ELITE Ti Installation Manual