Lowrance Elite-5 Ti Installation Manual - Page 45

Receive waypoint, Send waypoint, NMEA 0183 setup, Baud rate

Get Lowrance Elite-5 Ti PDF manuals and user guides View all Lowrance Elite-5 Ti manuals
Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

Receive waypoint Select this option to allow another device capable of creating and exporting waypoints via NMEA 2000 to transfer directly to this unit. Send waypoint Select this option to allow this unit to send waypoints to another device via NMEA 2000. NMEA 0183 setup The NMEA 0183 port must be set to suit the speed of connected devices, and can be configured to output only the sentences required by listening devices. Receive waypoint Select this option to allow a device capable of creating and exporting waypoints via NMEA 0183 to transfer directly to this unit. Baud rate This should be set to correspond with devices connected to the NMEA 0183 input and output. The input and output (Tx, Rx) use the same baud rate setting. Ú Note: AIS transponders typically operate at NMEA 0183-HS (high speed), and will require the baud rate to be set to 38,400. Software Setup | ELITE Ti Installation Manual 45

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
Receive waypoint
Select this option to allow another device capable of creating and
exporting waypoints via NMEA 2000 to transfer directly to this unit.
Send waypoint
Select this option to allow this unit to send waypoints to another
device via NMEA 2000.
NMEA 0183 setup
The NMEA 0183 port must be set to suit the speed of connected
devices, and can be configured to output only the sentences
required by listening devices.
Receive waypoint
Select this option to allow a device capable of creating and
exporting waypoints via NMEA 0183 to transfer directly to this unit.
Baud rate
This should be set to correspond with devices connected to the
NMEA 0183 input and output. The input and output (Tx, Rx) use the
same baud rate setting.
Ú
Note:
AIS transponders typically operate at NMEA 0183-HS
(high speed), and will require the baud rate to be set to
38,400.
Software Setup
| ELITE Ti Installation Manual
45