MSI K9MM-V User Guide - Page 13

MSI Reminds You... If you install two hard disks on one cable, you must configure the second drive to Slave mode by setting its jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper setting instructions. Serial ATA Connector: SATA1/SATA2 The mainboard provides 2 high-speed Serial ATA interface ports. The ports support 1ST generation Serial ATA data rates of 150MB /s and are fully compliant with Serial ATA 1.0 specifications. Each Serial ATA connector can connect to 1 hard disk device. MSI Reminds You... Please do not fold the serial ATA cable in a 90-degree angle, which will cause the loss of data during transmission. CD In Connector: CD_IN1 The connector is for CD-ROM audio connector. R GND L Chassis Intrusion Switch Connector: JCASE1 This connector is connected to a 2-pin chassis switch. GND 2 CINTRU 1 Fan Power Connectors: CPUFAN1/SFAN1 The CPUFAN1 (processor fan) and SFAN1 (system fan) support system cooling fan with +12V. When connecting the wire to the connectors, always take note that the red wire is the Sensor +12V GND GND +12V Sensor positive and should be connected to the +12V, the black wire is Ground and should be connected to GND. If the mainboard has a System Hardware Monitor chipset on-board, you must use a specially designed fan with speed sensor to take advantage of the CPU fan control. MSI Reminds You... Always consult the vendors for the proper CPU cooling fan. Front Panel Connectors: JFP1/ JFP2 The mainboard provides a front panel connector for electrical connection to the front panel switches and LEDs. JFP1 is compliant with Intel® Front Panel I/O Connectivity Design Guide. Reset HDD Switch LED Power LED 9 1 10 2 7 1 8 2 PowerPower Switch LED Speaker JFP1 JFP2 7