MSI K9N SLI-F User Guide - Page 25
Installing DDRII Modules
UPC - 816909043235
View all MSI K9N SLI-F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Hardware Setup Installing DDRII Modules 1. The memory module has only one notch on the center and will only fit in the right orientation. 2. Insert the memory module vertically into the DIMM slot. Then push it in until the golden finger on the memory module is deeply inserted in the socket. Important You can barely see the golden finger if the memory module is properly inserted in the socket. 3. The plastic clip at each side of the DIMM slot will automatically close. Volt Notch Important - DDRII modules are not interchangeable with DDR and the DDRII standard is not backwards compatible. You should always install DDRII memory modules in the DDRII DIMMs and DDR memory modules in the DDR DIMMs. - In dual-channel mode, make sure that you install memory modules of the sam e ty pe and d ensi ty in different channel DDR DIMMs. - To enable successful system boot-up, always insert the memory modules into the DIM M1 first. - Due to the chipset resource deployment, the system density will only be detected up to 7+GB (not full 8GB) when each DIMM is installed with an 2GB memory module. 2-7