MSI MS91F7 User Guide - Page 16

CPU Installation, Hardware Setup, make sure the CPU has a cooler attached on the top

Get MSI MS91F7 PDF manuals and user guides View all MSI MS91F7 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

▍ Hardware Setup CPU Installation When you are installing the CPU, make sure the CPU has a cooler attached on the top to prevent overheating. Meanwhile, do not forget to apply some thermal paste on CPU before installing the heat sink/cooler fan for better heat dispersion. Follow the steps below to install the CPU correctly. Wrong installation will cause the damage of your CPU & mainboard. 1. The CPU socket has a plastic cap on it to protect the contact from damage. Before you install CPU, always cover it to protect the socket pin. Remove the cap from the lever hinge side. 2. Raise the load lever up to its full extent. 3. Open the load plate. 4. After confirming the CPU direction for correct mating, put down the CPU in the socket housing frame. Be sure to grasp on the edge of the CPU base. Note that the alignment keys are matched. Alignment Key 2-4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
2-4
Hardware Setup
▍
CPU Installation
When you are ±nstall±ng the CPU,
make sure the CPU has a cooler attached on the top
to prevent overheat±ng. Meanwh±le, do not forget to apply some thermal paste on CPU
before ±nstall±ng the heat s±nk/cooler fan for better heat d±spers±on.
Follow the steps below to ±nstall the CPU correctly. Wrong ±nstallat±on w±ll cause the
damage of your CPU & ma±nboard.
The CPU socket has a plastic cap on
it to protect the contact from damage.
Before you install CPU, always cover
it to protect the socket pin. Remove
the cap from the lever hinge side.
1.
Raise the load lever up to its full
extent.
2.
Open the load plate.
3.
After confirming the CPU direction
for correct mating, put down the
CPU in the socket housing frame.
Be sure to grasp on the edge of the
CPU base. Note that the alignment
keys are matched.
4.
Al±gnment Key