MSI MSS0101 User Guide - Page 40

CompactFlash Slot, Master, ATA133, Slave

Get MSI MSS0101 PDF manuals and user guides View all MSI MSS0101 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

▍ Hardware Setup CompactFlash Slot This CompactFlash slot shares one channel of the IDE controller and supports one CompactFlash type I / type II device. Important • The CF1 slot and the IDE1 connector shares and uses the same channel. CF1 and IDE1 can support up to 2 IDE devices without CF device or 1 IDE device with 1 CF device. • If you install two IDE devices, you must configure the second drive to Slave mode by setting its jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper setting instructions. • If you install one CF device and one IDE device with ATA133 IDE cable, you must configure the CF drive to Master mode by setting jumper JCF_SEL1. CF only supports Master mode by using ATA133 IDE cable. CF only supports Slave mode by using ATA33 IDE cable. 2-24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
2-24
Hardware Setup
▍
CompactFlash Slot
Th±s CompactFlash slot shares one channel of the IDE controller and supports
one CompactFlash type I / type II dev±ce.
Important
The CF1 slot and the IDE1 connector shares and uses the same channel. CF1
and IDE1 can support up to 2 IDE devices without CF device or 1 IDE device
with 1 CF device.
If you install two IDE devices, you must configure the second drive to Slave
mode by setting its jumper. Refer to the hard disk documentation supplied by
hard disk vendors for jumper setting instructions.
If you install one CF device and one IDE device with ATA133 IDE cable, you
must configure the CF drive to Master mode by setting jumper JCF_SEL1.
CF only supports
Master
mode by using
ATA133
IDE cable. CF only supports
Slave
mode by using
ATA33
IDE cable.
•
•
•