MSI MSS0101 User Guide - Page 5

CE Conformity, FCC-B Radio Frequency Interference Statement

Get MSI MSS0101 PDF manuals and user guides View all MSI MSS0101 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

MS-S0101 CE Conformity Hereby, Micro-Star International CO., LTD declares that this device is in compliance with the essential safety requirements and other relevant provisions set out in the European Directive. FCC-B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the measures listed below: ￭ Reorient or relocate the receiving antenna. ￭ Increase the separation between the equipment and receiver. ￭ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ￭ Consult the dealer or an experienced radio/television technician for help. Notice 1 The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Notice 2 Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission limits. VOIR LA NOTICE D'INSTALLATION AVANT DE RACCORDER AU RESEAU. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. 

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
v
MS-S0101
CE Conformity
Hereby, M±cro-Star Internat±onal CO., LTD declares that th±s dev±ce
±s ±n compl±ance w±th the essent±al safety requ±rements and other
relevant prov±s±ons set out ±n the European D±rect±ve.
FCC-B Radio Frequency
Interference Statement
Th±s equ±pment has been tested and found to comply w±th the l±m±ts for a Class B
d±g±tal dev±ce, pursuant to Part 15 of the FCC Rules. These l±m±ts are des±gned to
prov±de reasonable protect±on aga±nst harmful ±nterference ±n a res±dent±al ±nstal-
lat±on. Th±s equ±pment generates, uses and can rad±ate rad±o frequency energy
and, ±f not ±nstalled and used ±n accordance w±th the ±nstruct±on manual, may
cause harmful ±nterference to rad±o commun±cat±ons. However, there ±s no guar-
antee that ±nterference w±ll not occur ±n a part±cular ±nstallat±on. If th±s equ±pment
does cause harmful ±nterference to rad±o or telev±s±on recept±on, wh±ch can be
determ±ned by turn±ng the equ±pment off and on, the user ±s encouraged to try to
correct the ±nterference by one or more of the measures l±sted below:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/television technician for
help.
Notice 1
The changes or modifications not expressly approved by the party responsible for
compl±ance could vo±d the user’s author±ty to operate the equ±pment.
Notice 2
Sh±elded ±nterface cables and AC power cord, ±f any, must be used ±n order to
comply w±th the em±ss±on l±m±ts.
VOIR LA NOTICE D’INSTALLATION AVANT DE RACCORDER AU RESEAU.
Th±s dev±ce compl±es w±th Part 15 of the FCC Rules. Operat±on ±s subject to the
follow±ng two cond±t±ons:
th±s dev±ce may not cause harmful ±nterference, and
th±s dev±ce must accept any ±nterference rece±ved, ±nclud±ng ±nterference that
may cause undes±red operat±on.
￭
￭
￭
￭
1)
2)