Mackie SP2400 Instruction Manual - All - Page 24

SP2400 Specifications Power Amplifier Section Continuous Sine Wave Average Output Power, both channels driven: 200 watts per channel into 8 ohms from 20Hz to 20kHz, with no more than 0.01% THD 100V rms per channel into 50 ohms from 20Hz to 20kHz, with no more than 0.1% THD (J2/J3 in 100V position) 70V rms per channel into 25 ohms from 20Hz to 20kHz, with no more than 0.1% THD (J2/J3 in 70V position) Frequency Response 20Hz to 20kHz (+0, -0.5 dB) Distortion THD: < 0.01% @ rated output into 8 ohms Signal-To-Noise Ratio > 90 dB below rated power into 8 ohms > 100 dB (A-weighted) below rated power into 8 ohms Channel Separation > 80 dB @ 1kHz Amp Input Impedance 20K ohms Input Sensitivity +5 dBu (1.37V rms) for rated power into 8 ohms Gain 27 dB (8-ohm position) 27 dB (70V position) 30 dB (100V position) Maximum Input Level 12 volts P-P (+15 dBu) Rise Time < 5 µS Slew Rate > 17 V/µS EQ 3-Band Program EQ: High Shelving: Mid Peaking: Low Shelving: ±15 dB @ 12kHz ±15 dB with sweepable frequency (250Hz to 8kHz) ±15 dB @ 80Hz 2-Band Mic EQ: High Shelving: Low Shelving: ±12 dB @ 12kHz ±12 dB @ 100Hz General Power Consumption 700 watts with musical program, 8 ohms per side 800 watts maximum Phantom Power 24 VDC AC Line Voltage 115VAC, 60Hz 230VAC, 50Hz Fuse Rating 115V 230V 8A Slow Blow, 250V 4A Slow Blow, 250V Dimensions Height: Width: Depth: Weight: 3.5" (88mm) 19" (483mm) 16.7" (424mm) 40 lbs. (18.1kg) Accessories MT-3100 SP-41R Ambient Noise Sensing Microphone Remote Control Preamplifier Section Input Levels Program Inputs: Paging Mic Input: Local Mic Input: -10 dBu to +10 dBu for maximum output level with internal AGC -52 dBu to +4 dBu -52 dBu to +4 dBu Maximum Input Program Inputs: Mic Inputs: +15 dBu +15 dBu Maximum Output at Pre Out +10 dBu Stereo Separation > 45 dB at 1kHz SP2400 - 24