Mackie d.2 Owner's Manual - Page 26
Replacing Faders
View all Mackie d.2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
d.2 2-channel DJ Mixer Replacing Faders If the faders ever need to be replaced, this can be done with the help of your trusty screwdriver. 10. Follow steps 1 to 5 and remove the top panel. 11. Take care to only remove the two outer screws of each fader you are replacing, as shown below. 14. Secure the fader assembly to the chassis with the two screws you lost in step 11. 15. Replace the top cover, and make sure that all the meter LEDs and the Reverse LEDs are poking through before you tighten down the screws securely. 16. Check that all the faders and switches are working normally. (You might have to reset the tension if you changed the cross fader.) 12. Gently lift up the fader assembly, just enough to be able to pull the connector out of the receptacle on the bottom of the fader assembly. Removing the Cross Fader Connector Removing a Program Fader Connector 13. Insert the connector into the receptacle on the new fader assembly. (It will only fit in one way.) 26 d.2 DJ Mixer